Logging Console - Dell S4810 Reference Manual

Defaults level = 7; size = 40960 bytes
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage When you decrease the buffer size, all messages stored in the buffer are lost.
Information Increasing the buffer size does not affect messages stored in the buffer.
Related
clear logging
Commands
default logging buffered
setting.
show logging
buffer.

logging console

Specify which messages are logged to the console.
S4810
Syntax
logging console [level]
To return to the default values, use the default logging console command.
To disable logging to the console, use the no logging console command.
Simple Network Management Protocol (SNMP) and Syslog
each message. The range is from 40960 to 524288. The
default is 40960 bytes.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— clears the logging buffer.
— returns the logging buffered parameters to the default
— displays the logging setting and system messages in the internal
1585