Interior Lights
Interior Light Switch Test
1. Remove the center panel (see page 20-70).
2. Push the switch (A) out from the center panel.
B
3. Disconnect the 6P connector (B) from the switch.
4. Check for continuity between the terminals in each
switch position according to the table.
Terminal
1
Position
OFF
MIDDLE
ON
5. If the continuity is not as specified, replace the bulb
(C) or the switch.
22-148
22-148
C
A
2
4
3
5
6
Tailgate Latch Switch Test
1. Open the tailgate.
2. Remove the tailgate lower trim (see page 20-61).
3. Disconnect the 2P connector (A) from the latch
switch.
A
4. Check for continuity between the No. 1 and No. 2
terminals.
• With the tailgate open, there should be continuity.
• With the tailgate closed, there should be no
continuity.
5. If the continuity is not as specified, replace the
tailgate latch switch.
Terminal side of
male terminals