Honda 2004 Odyssey Service Manual page 1843

Accessory Power Sockets
Front Accessory Power Socket Test/Replacement
1. Remove the center pocket (see page 20-67).
2. Disconnect the 2P connector.
3. Inspect the connector terminals to be sure they are
all making good contact.
• If the terminals are bent, loose or corroded,
repair them as necessary, and recheck the
system.
• If the terminals look OK, go to step 4.
Wire side of
female terminals
4. Turn the ignition switch to ACC (I).
5. Check for voltage between the No. 1 and No. 2
terminals.
• There should be battery voltage.
• If there is no battery voltage, check for:
– blown No. 8 (7.5A) fuse in the driver's under-
dash fuse/relay box.
– faulty accessory power socket relay.
– poor ground (G 501, G581).
– an open in the wire.
– blown No. 9 (15A) in the passenger's under-
dash fuse/relay box.
22-164
6. Remove the housing (A) and socket (B).
BLK
WHT/RED
A
B