Front Individual Map Light Test
1. Carefully pry off the lens (A) with a small
screwdriver.
FRONT MAP LIGHT BULB: 6.2 W
D
2. Remove the four mounting screws (B).
3. Disconnect the 3P connector (C) from the housing
(D).
4. Check for continuity between the terminals in each
switch position according to the table.
Terminal
Position
LEFT
C
RIGHT
B
A
5. If the continuity is not as specified, check the
bulb(s). If the bulb(s) are OK, replace the light.
1
2
ON
OFF
ON
OFF
3
22-149