Door Outer Handle Replacement - Honda S2000 Service Manual

Door Outer Handle Replacement
N O T E :
. Put on gloves to protect your hands.
. Take care not to scratch the door
. Take care not to bend each rod.
' 1 .
2.
3 .
Remove these items:
. D o o r o a n e l
. Plastic cover, as necessary (see page 20-2)
Remove the door outer handle in numbered sequence
lnstall the outer handle in the reverse order of removal, and note these items:
. Make sure the cylinder switch harness is routed properly.
. Make sure the cylinder switch connector is plugged in properly, and each rod is connected securely.
. When installing the lock cylinder, leave the outer handle bolts loose so the outer handle protector does not
interfere with the lock cylinder installation, then tighten the handle bolts
. I n s t a l l t h e r e t a i n e r c l i p o n t h e o u t e r h a n d l e , t h e n i n s t a l l t h e l o c k c y l i n d e r . B e s u r e t h e r e t a i n e r c l i p i s f u l l y s e
in the slot on the lock cylinder.
. Make sure the door locks and opens properly.
. When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its
perimeter.
Fastener Locations
O Raise the glass fully.
LOCK CYLINDER
CYLINDER SWITCH
HOLE SEAL
A > : S c r e w , 1 B > r S c r e w , 1
C=" O-
i!] RETAINER CLIP
-
- ' . : . ' \ J
-
)};i
a\
\
\, l?\
. .
€ ROD PROTECTOR
i9-, HARNESS CLIPS
Detach.
{cont'd)
:-,
O CYLINDER SWTTCH HARNESS
CONNECTOR
Disconnect,
20-5