Honda 2004 Odyssey Service Manual page 1879

Power Windows
System Description
'03-04 models
The driver's window will stop and automatically open if you pinch your hand or something during auto-up operation.
The system is composed of the power window master switch, the power window control unit and the driver's window
motor.
The power window motor incorporates a pulser which generates pulses during the motor's operation and sends the
pulses to the power window control unit. As soon as the power window control unit detects no pulses from the pulser,
the control unit makes the power window motor stop and reverse.
POWER WINDOW MASTER
SWITCH
POWER WINDOW MOTOR
Sensor
MAGNET
Resetting the Power Window Control Unit
'03-04 models
Resetting the power window control unit is required after performing the following procedures
• Disconnecting the battery.
• Removing the No. 79 (20A) fuse in the under-hood subfuse box.
• Disconnecting the 18P connector from the power window control unit.
• Removing the window regulator, glass or glass run channel.
• Disconnecting the driver's door wire harness.
1. Turn the ignition switch off, then back ON (II).
2. Move the driver's window all the way down by holding the driver's switch to the AUTO DOWN position; when the
window reaches the bottom, hold the driver's window switch in the AUTO DOWN position for 2 seconds.
3. Move the driver's window all the way up without stopping by holding the driver's switch to the AUTO UP position;
when the window reaches the top, hold the driver's window switch in the AUTO UP position for 2 seconds.
If the window does not work in AUTO, reset the power window control unit according to the above procedures again.
22-200
POWER WINDOW
CONTROL UNIT
Period of pulses
N S IC
Period of pulses
IC
Period of
pulses
Threshold value for
judgement of pinching
HALL IC UNIT
Position when something
is pinched
MAGNET