Mpc Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

MPC Error

3-114
Multi-Protocol Network Card error has occurred. The following
troubleshooting procedure applies to these errors.
Applicable Chain Link
Chain Link
Communication has failed between the MPC and the Controller.
Chain Link
Checksum Error) – Checksum errror in MPC Flash ROM.
Chain Link
RAM R/W check has detected an error.
Chain Link
Checksum Error) – Checksum error occurred in the MPC Flash ROM.
Chain Link
Checksum error occurred in the MPC MAC Address.
Chain Link
Error) – The MPC Ethernet BIST parity RAM R/W has detected an error.
Chain Link
Loopback test has detected an error.
Chain Link
detected an error.
Chain Link
detected an error.
Chain Link
VxWORKS has detected an error.
Chain Link
errror has occurred.
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.20
Multi-Protocol Network Card
(Option), PL9.1.23
018-310: MPC Error (NIC ESS Communication) -
018-311: MPC Error (NIC Flash ROM Boot Module
018-312: MPC Error (NIC RAM R/W Test Error) – The MPC
018-313: MPC Error (NIC Flash ROM Application Module
018-314: MPC Error (NIC MAC Address Checksum Error) –
018-315: MPC Error (NIC Ethernet BIST Parity/RAM R/W
018-316: MPC Error (NIC Internal Loopback Error) – The
018-317: MPC Error (NIC Fatal Error) – MPC check has
018-319: MPC Error (MPC OS Error) – MPC Network OS has
018-320: MPC Error (MPC VxWorks Error) – MPC
116-333: MPC Error (PCI Option #0 Failure) – PCI option 0
Wiring and Plug/Jack Map References
Phaser 6180MFP Multifunction Printer Service Manual