Fax Codec Error - Xerox Phaser 6180MFP Service Manual

Fax Codec Error

Phaser 6180MFP Multifunction Printer Service Manual
The Fax has failed. The following troubleshooting procedure applies to this
error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
Fax Board, PL9.1.3
Troubleshooting Procedure Table
Step Actions and Questions
Is the dial number correct?
1
2 1. Check the Parameter setting:
Service Mode
Parameter.
2. Does Chain Link value 825-662
show on the Control Panel menu?
3 1. Check the country setting:
Admin Menu
Country.
2. Is the country setting correct?
1. Check the Fax Board for correct
4
installation. Reseat the Fax Board
(page 8-98).
2. Does the error still occur when
faxing?
5 1. Check the Scanner Controller Board
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2. Does the error still occur when
faxing?
033-773: Fax Codec Error (Undefined Marker Error)
Wiring and Plug/Jack Map References
> Fax/Scanner Diag
System
> Fax Settings >
Error Messages and Codes
Yes No
Go to step 2. Set the correct
dial number.
Go to step 3. Set the Chain
Link value to
825-662.
> Go to step 4. Set the country
setting to the
correct country.
Go to step 5. Complete.
Replace the Complete.
Scanner
Controller Board
(page 8-99).
3-205