Remove Print Cartridge Tape (Yellow/Magenta/Cyan/Black) - Xerox Phaser 6180MFP Service Manual

Remove Print Cartridge Tape (Yellow/Magenta/Cyan/Black)

Phaser 6180MFP Multifunction Printer Service Manual
The Print Cartridge (Yellow/Magenta/Cyan/Black) tape was not removed
when a new Print Cartridge is installed. The following troubleshooting
procedure applies to these errors.
Applicable Chain Links
Chain Link
Chain Link
Chain Link
Chain Link
Initial Actions
Check the Print Cartridge life using CentreWare IS.
Cycle printer power.
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Print Cartridge (Y/M/C/K),
PL5.1.17-20
Dispenser, PL5.2.10
MCU Board, PL9.2.13
Top LV Harness, PL10.1.3
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Print Cartridge tape. Has the
tape been removed?
2 Does the error still occur?
1. Replace the Print Cartridge
3
(page 8-11).
2. Does the error still occur?
093-919: Check Yellow Cartridge
093-920: Check Magenta Cartridge
093-921: Check Cyan Cartridge
093-922: Check Black Cartridge
Wiring and Plug/Jack Map References
"Map 3 - Image Processor Board and
Dispenser Motors" on page 10-12
"Map 4 - LVPS and MCU Board" on
page 10-13
"Developer" on page 10-38
Error Messages and Codes
Yes No
Go to step 2. Remove the
tape on the
Print Cartridge.
Go to step 2.
Go to step 3. Complete.
Go to step 4. Complete.
3-53