Nvram Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

NVRAM Error

3-150
The printer controller has detected NVRAM error. The following
troubleshooting procedure applies to these errors.
Applicable Chain Link
Chain Link
Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the Image Processor Board
for correct installation.
2. Is the Image Processor Board
correctly installed?
2 Does the error still occur when the
printer is turned On?
116-323: NVRAM Error (NVRAM1 W/R Check Fail)
116-326: NVRAM Error (NVRAM2 W/R Check Fail)
116-390: NVRAM Error (NVRAM1 Size and ID Check Fail)
Wiring and Plug/Jack Map References
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Reseat the
Image
Processor
Board
(page 8-90).
Replace the Complete.
Image
Processor Board
(page 8-90).