Reseat Mpc Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Reseat MPC Error

3-104
MPC download was attempted without MPC installed. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.20
Multi-Protocol Network Card
(Option), PL9.1.23
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the Multi-Protocol Network
1
Card (MPC) for correct installation.
2. Is the MPC installed on the Image
Processor Board?
2 1. Check the firmware for the MPC.
2. Does the firmware have the correct
version?
1. Check the MPC for correct
3
installation. Reseat the MPC
(page 8-95).
2. Does the error still occur after the
firmware has been updated?
1. Check the Image Processor Board
4
for correct installation. Reseat the
Image Processor Board
(page 8-90).
2. Does the error still occur after the
firmware has been updated?
016-739: Reseat MPC Error (Download Insertion Error)
Wiring and Plug/Jack Map References
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Install the MPC
(page 8-95).
Go to step 2.
Go to step 3. Update the
firmware
("Firmware
Update" on
page A-3).
Go to step 4. Complete.
Go to step 5. Complete.