Fax Communication Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Fax Communication Error

3-214
The Fax signal was not sent. The following troubleshooting procedure applies
to this error.
Applicable Chain Link
Chain Link
Signal Send)
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
ADF Scanner Assembly, PL11.1.1
Troubleshooting Procedure Table
Step Actions and Questions
1. Turn the printer power Off and back
1
On.
2. Does the error still occur?
2 1. Replace the Scanner Control Board
(page 8-99).
2. Does the error still occur when
copying and faxing?
034-508: Fax Communication Error (Command Refuse
Wiring and Plug/Jack Map References
"Automatic Document Feeder Wiring
Diagram" on page 10-53
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Complete.
Replace the ADF Complete.
Scanner
Assembly
(page 8-103).