Insert Tray 2 - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Insert Tray 2

3-76
The Tray 2 Size Switch indicates that Tray 2 is not installed. The following
troubleshooting procedure applies to these errors.
Applicable Chain Link
Chain Link
Chain Link
Initial Actions
Remove the tray and inspect the tray cavity to ensure that it is free of
obstructions or debris.
Reinstall the tray and cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Tray 2 Size Switch, PL7.1.18
MCU Board, PL9.2.13
Right Side Harness, PL10.1.12
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the tray for correct
installation.
2. Is Tray 2 correctly installed?
Does the error still occur when the
2
printer is turned On?
3 1. Perform the Tray 2 Paper Size test
(page 4-52):
Printer Diag
Sensor Test
2. Does the switch operate properly?
024-946: Insert Tray 2 (Tray Detached)
077-912: Insert Tray 2 (Upper Cassette Detached)
Wiring and Plug/Jack Map References
"Map 2 - Laser Unit and Feeder" on
page 10-11
"Map 4 - LVPS and MCU Board" on
page 10-13
"Feeder" on page 10-30
Service Mode >
> Engine Diag >
> Tray2 Paper Size.
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 3. Reseat Tray 2.
Go to step 3. Complete.
Complete. Go to step 4.