Check Sum Error
Phaser 6180MFP Multifunction Printer Service Manual
Checksum is invalid. The following troubleshooting procedure applies to this
error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.20
Troubleshooting Procedure Table
Step
Actions and Questions
1
1. Check the printer firmware.
2. Does the firmware have the correct
version?
1. Check the Image Processor Board
2
for correct installation. Reseat the
Image Processor Board
(page 8-90).
2. Does the error still occur?
016-744: Check Sum Error (Download Check Sum Error)
Wiring and Plug/Jack Map References
Error Messages and Codes
Yes
No
Go to step 2.
Update the
firmware (refer
to "Firmware
Update" on
page A-3).
Replace the
Complete.
Image
Processor Board
(page 8-90).
3-111