Fax Codec Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Fax Codec Error

3-186
The Fax has failed. The following troubleshooting procedure applies to this
error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Turn the printer power Off and back
On.
2. Does the error still occur when
faxing after turning the printer back
On?
2 1. Check the Fax Parameter setting:
Service Mode
> Parameter.
2. Enter Chain Link 825-662.
3. Does the value [Hex] show number
2 (MMR)? (refer to "Chain Link for
Fax Parameter Setting" on page A-9
for detailed information)
3 1. Check the Scanner Controller Board
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2. Does the error still occur when
faxing?
033-510: Fax Codec Error
Wiring and Plug/Jack Map References
> Fax/Scanner Diag
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Complete.
Go to step 3. Change the
value ([Hex] to
2.
Replace the Complete.
Scanner
Controller Board
(page 8-99).