Xerox Phaser 6180MFP Service Manual page 454

General Troubleshooting
4-42
Exit Sensor
Warning
Ensure to wait for the Fuser to cool down before starting the procedure.
1. Enter the Service Diagnostic menu (page 4-5).
2. Open the Front Cover.
3. Remove the Transfer Unit (page 8-9).
4. Perform the Exit Sensor test:
> Exit Sensor
5. Move the Sensor up and down and check the information on the Control
Panel display. The Low and High values change from 0 up to 99.
Control Panel
6. Press the Stop button to stop the Exit Sensor test.
Printer Diag
> OK.
Normal
Exit Sensor
L-0
Phaser 6180MFP Multifunction Printer Service Manual
> Engine Diag > Sensor Test
Exit Sensor
H-0
s6180mfp-161