Replace Transfer Unit - Xerox Phaser 6180MFP Service Manual

Replace Transfer Unit

Phaser 6180MFP Multifunction Printer Service Manual
The Transfer Unit has reached its end of life. The following troubleshooting
procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Check the Transfer Unit life using CentreWare IS.
Cycle printer power.
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Transfer Unit, PL4.1.1
MCU Board, PL9.2.13
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the Transfer Unit life using
1
CentreWare IS.
2. Does the Level show 0%?
Does the error still occur when the
2
printer is turned On?
094-911: Replace Transfer Unit (IOT DTB Life Over)
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-10
"Map 4 - LVPS and MCU Board" on
page 10-13
"Xerographic" on page 10-34
Error Messages and Codes
Yes No
Replace the Go to step 2.
Transfer Unit
(page 8-9).
Replace the Complete.
MCU Board
(page 8-88).
3-69