Network Not Ready, Scan Aborted Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Network Not Ready, Scan Aborted Error

3-172
The scan job has been aborted due to network not ready. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
Chain Link
TCP Error)
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the network setting using a
1
PC.
2. Is the setting correct?
1. Check the network setting:
2
Admin Menu
2. Is the printer network setting
correct?
1. Check the Protocol setting:
3
>
>
2. Is SMB TCP/IP disabled?
1. Check the Image Processor Board
4
for correct installation. Reseat the
Image Processor Board
(page 8-90).
2. Does the error still occur when the
printer power is turned On?
016-794: Network Not Ready, Scan Aborted Error (SMB Over
System
> Network Settings.
System
Admin Menu > Network Settings
Protocol > SMB TCP/IP?
Phaser 6180MFP Multifunction Printer Service Manual
Wiring and Plug/Jack Map References
Yes
Go to step 2.
> Go to step 3.
Set SMB TCP/I/
P to Enable.
Replace the
Image
Processor Board
(page 8-90).
No
Set the correct
network
information.
Set the correct
network
settings.
Go to step 4.
Complete.