Xerox Phaser 6180MFP Service Manual page 387

Target Fax Busy Error
Phaser 6180MFP Multifunction Printer Service Manual
The target device opens the line by detecting busy tone while calling the
external telephone. The following troubleshooting procedure applies to this
error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
Fax Board, PL9.1.3
Troubleshooting Procedure Table
Step Actions and Questions
Is the dial number correct?
1
1. Check the telephone line connection.
2
Reconnect the telephone line
connector on the Scanner Controller
Board.
2. Does the error still occur when
faxing?
1. Check the Fax Board installation.
3
Reseat the Fax Board (page 8-98).
2. Does the error still occur when
faxing?
4 1. Check the Scanner Controller Board
installation. Reseat the Scanner
Controller Board (page 8-99).
2. Does the error still occur when
faxing?
033-752: Target Fax Busy (During Call Busy Tone)
Wiring and Plug/Jack Map References
Error Messages and Codes
Yes No
Go to step 2. Set the correct
dial number.
Go to step 3. Complete.
Go to step 4. Complete.
Replace the Complete.
Scanner
Controller Board
(page 8-99).
3-199