Printer Continually Displays Insert Print Cartridge - Xerox Phaser 6180MFP Service Manual

Printer Continually Displays Insert Print Cartridge

Phaser 6180MFP Multifunction Printer Service Manual
Initial Actions
Check the Print Cartridge life using CentreWare IS.
Cycle printer power.
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Print Cartridge (Y/M/C/K),
PL5.1.17-20
Print Cartridge Sensor, PL5.2.6
MCU Board, PL9.2.13
Toner Sensor Harness, PL10.1.7
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the Print Cartridge for correct
installation.
2. Is the Print Cartridge correctly installed?
2 Does the error still occur?
1. Perform the CRU Sensor test:
3
Mode
Sensor Test
2. Does the number on the Control Panel
increase by 1 when the Print Cartridge is
reseated?
1. Replace the Print Cartridge (page 8-11).
4
2. Does the error still occur?
1. Check the Toner Sensor wiring harness
5
connectors between the Print Cartridge
Sensor and the MCU Board.
2. Are the connectors securely connected?
6 Does the error still occur?
> Printer Diag > Engine Diag
> CRU Sensor.
Yellow CRU Sensor (page 4-45)
Magenta CRU Sensor (page 4-46)
Black CRU Sensor (page 4-47)
Cyan CRU Sensor (page 4-48)
Yellow: P/J19 and P/J191
Magenta: P/J19 and P/J192
Black: P/J19 and P/J193
Cyan: P/J19 and P/J194
General Troubleshooting
Wiring and Plug/Jack Map References
"Developer" on page 10-38
Yes
Go to step 3.
Go to step 3.
Service Replace the
> MCU Board
(page 8-88).
Go to step 5.
Go to step 6.
Go to step 7.
No
Reseat the
Print
Cartridge
(page 8-11).
Complete.
Go to step 4.
Complete.
Reconnect
the
connectors.
Go to step 6.
Complete.
4-81