Fan Motor Error (Duplex Fan) - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Fan Motor Error (Duplex Fan)

3-122
Error for the Duplex Fan Motor has occurred. The following troubleshooting
procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Front Cover Harness, PL1.2.13
MCU Board, PL9.2.13
Right Side Harness, PL10.1.12
Duplex Unit, PL12.1.1
Duplex Harness, PL12.1.18
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Perform the Duplex Fan test
(page 4-77):
Printer Diag
Test
2. Does the Motor operate properly?
1. Check the Duplex Unit installation.
2
Reseat the Duplex Unit
(page 8-115).
2. Does the error still occur when the
printer is turned On?
1. Check the wiring harness
3
connectors P/J27, P/J272, P/J2720,
and P/J428 between the Duplex
Board and the MCU Board.
2. Are the connectors securely
connected?
042-313: Fan Motor Error (IOT Fan Motor Failure)
Wiring and Plug/Jack Map References
page 10-10
page 10-13
Service Mode >
> Engine Diag > Motor
> Duplex Fan.
Phaser 6180MFP Multifunction Printer Service Manual
"Map 1 - Electrical and Drive" on
"Map 4 - LVPS and MCU Board" on
"Map 5 - Duplex Unit" on page 10-14
"DC Power Supply" on page 10-24
"Duplex Wiring Diagram" on page 10-48
Yes No
Replace the Go to step 2.
MCU Board
(page 8-88).
Go to step 3. Complete.
Go to step 4. Go to step 8.