Macphy Internal Loop Test Error - Xerox Phaser 6180MFP Service Manual

MACPHY Internal Loop Test Error

Phaser 6180MFP Multifunction Printer Service Manual
MACPHY Internal Loop Test error has occurred. The following troubleshooting
procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.27
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Reboot the printer.
2. Does the error still occur?
2 1. Reseat the Image Processor Board.
2. Does the error still occur?
116-393: MACPHY Int Loop Test Error (Diag Mode)
Wiring and Plug/Jack Map References
Error Messages and Codes
Yes No
Go to step 2. Complete.
Replace the Complete.
Image
Processor Board
(page 8-90).
3-155