Asic Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

ASIC Error

3-152
The printer controller has detected error. The following troubleshooting
procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the Image Processor Board
for correct installation.
2. Is the Image Processor Board
correctly installed?
Does the error still occur when the
2
printer is turned On?
116-343: ASIC Error (ASIC Fail)
Wiring and Plug/Jack Map References
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Reseat the
Image
Processor
Board
(page 8-90).
Replace the Complete.
Image
Processor Board
(page 8-90).