Environmental (Humidity/Temperature) Sensor Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Environmental (Humidity/Temperature) Sensor Error

3-144
The Environmental Sensor has detected temperature error. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
Chain Link
Sensor Error)
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Humidity/Temperature Sensor
PL9.2.11
MCU Board, PL9.2.13
Humidity Harness, PL10.1.15
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the Humidity/Temperature
1
Sensor for correct installation.
2. Is the Humidity/Temperature Sensor
correctly installed?
2 Does the error still occur when the
printer is turned On?
1. Check the wiring harness
3
connectors P/J26 and P/J261
between the MCU Board and the
Humidity/Temperature Sensor.
2. Are the connectors securely
connected?
092-661: Environmental Sensor Error (IOT Environment
Wiring and Plug/Jack Map References
"Map 4 - LVPS and MCU Board" on
page 10-13
"Xerographic" on page 10-34
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Reseat the
Humidity/
Temperature
Sensor.
Go to step 2.
Go to step 3. Complete.
Go to step 4. Reconnect the
connectors.