Door A Open - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Door A Open

3-138
The Front Cover is open. The following troubleshooting procedure applies to
this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Front Cover, PL1.2.1
Interlock Harness, PL9.2.3
MCU Board, PL9.2.13
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the Front Cover for damages.
1
2. Are there any damages on the Front
Cover?
2 Check the Interlock Switch for
operation.
1. Perform the Interlock Switch test
(page 4-44):
Printer Diag
Sensor Test
2. Does the Switch operate properly?
1. Replace the Interlock Switch
3
Harness (page 8-82).
2. Does the error still occur when the
printer is turned On?
077-300: Door A Open (IOT Front Cover Open)
Wiring and Plug/Jack Map References
Service Mode >
> Engine Diag >
> Interlock Switch.
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Replace the Go to step 2.
Front Cover
(page 8-28).
Replace the Go to step 3.
MCU Board
(page 8-88).
Replace the Complete.
MCU Board
(page 8-88).