Task Error - Xerox Phaser 6180MFP Service Manual

Task Error

Phaser 6180MFP Multifunction Printer Service Manual
Communication error has occurred while performing a copy job. The following
troubleshooting procedure applies to these errors.
Applicable Chain Link
Chain Link
Chain Link
AIOC)
Chain Link
Transmission Error)
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
Image Processor Board, PL9.1.20
AIO-ESS Harness Assembly
PL10.1.14
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Turn the printer Off, wait for five
seconds, and turn the printer back
On.
2. Does the error still occur when
copying?
1. Check the wiring harness connector
2
P/J480 on the Image Processor
Board. Reseat the connector.
2. Does the error still occur when
copying?
1. Check the wiring harness connector
3
P/J48 on the Scanner Controller
Board. Reseat the connector.
2. Does the error still occur when
copying?
116-397: Controller Error (Communication Error with AIOC)
116-398: Controller Error (Communication Time Out with
117-313: Controller Communication Error (ESS Data
Wiring and Plug/Jack Map References
"Map 3 - Image Processor Board and
Dispenser Motors" on page 10-12
"Fax Controller Wiring Diagram" on
page 10-50
Error Messages and Codes
Yes No
Go to step 2. Complete.
Go to step 3. Complete.
Go to step 4. Complete.
3-159