Xerox Phaser 6180MFP Service Manual page 315

Phaser 6180MFP Multifunction Printer Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
1. Perform the Main Motor test
5
(page 4-54): Service Mode >
Printer Diag > Engine Diag > Motor
Test > Main Motor. During the test,
close the Front Cover.
2. Does the Motor operate properly?
1. Check the Main Drive Assembly for
6
correct installation.
2. Is the Main Drive Assembly securely
installed?
7 Does the error still occur when the
printer is turned On?
Check the Right Side Harness for
8
continuity.
1. Disconnect P/J21 from the MCU
Board.
2. Disconnect P/J211 from the Main
Drive Assembly.
3. Check continuity between P/J21 <=>
P/J211.
9 Check the Main Drive signal.
1. Disconnect P/J21 on the MCU
Board.
2. Is there +24 V across ground <=>
J21-2/J21-4 pin when the Interlock
Switch is activated?
Error Messages and Codes
Yes No
Replace the Go to step 6.
MCU Board
(page 8-88).
Go to step 7. Reseat the Main
Drive Assembly
(page 8-75).
Go to step 7.
Go to step 8. Complete.
Go to step 9. Replace the
Right Side
Harness.
Replace the Replace the
Main Drive MCU Board
Assembly (page 8-88).
(page 8-75).
3-127