Control Panel Error - Xerox Phaser 6180MFP Service Manual

Control Panel Error

Phaser 6180MFP Multifunction Printer Service Manual
The parameter setting on the Control Panel has failed. The following
troubleshooting procedure applies to these errors.
Applicable Chain Link
Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Control Panel, PL1.2.2
Scanner Controller Board, PL9.1.1
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Wait for 5 seconds and turn the
printer Off and back On.
2. Does the error still occur when the
printer is turned On?
1. Check the Scanner Controller Board
2
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2. Does the error still occur when the
printer is turned On?
1. Check the Control Panel for correct
3
installation. Reseat the Control
Panel (page 8-30).
2. Does the error still occur when the
printer is turned On?
1. Replace the Scanner Controller
4
Board (page 8-99).
2. Does the error still occur when the
printer is turned On?
062-323: Panel Setting Parameter NG
123-314: Control Panel Error
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-10
"Automatic Document Feeder Wiring
Diagram" on page 10-53
Error Messages and Codes
Yes No
Go to step 2. Complete.
Go to step 3. Complete.
Go to step 4. Complete.
Replace the Complete.
Control Panel
(page 8-30).
3-183