Scanner Error - Xerox Phaser 6180MFP Service Manual

Scanner Error

Phaser 6180MFP Multifunction Printer Service Manual
The Scanner has failed. The following troubleshooting procedure applies to
these errors.
Applicable Chain Link
Chain Link
Chain Link
Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
ADF Scanner Assembly, PL11.1.1
Troubleshooting Procedure Table
Step Actions and Questions
Check the Scanner Lock. Is the
1
Scanner Lock at the Unlock position?
1. Check the wiring harness
2
connectors P/J60, P/J62, P/J63, P/
J64, and P/J65 on the Scanner
Controller Board. Reseat the
connectors.
2. Does the error still occur when the
printer power is turned On?
3 1. Replace the ADF Scanner Assembly
(page 8-103).
2. Does the error still occur when the
printer is turned On?
062-311: Scanner Initial Error
062-321: Scanner Malfunction
062-360: Scanner Sensor Error
062-371: Scanner Lamp Error
Wiring and Plug/Jack Map References
"Automatic Document Feeder Wiring
Diagram" on page 10-53
Error Messages and Codes
Yes No
Go to step 2. Set the Scanner
Lock to the
Unlock position.
Go to step 3. Complete.
Replace the Complete.
Scanner
Controller Board
(page 8-99).
3-177