General Information
Warm-Up Time
First Print Output Time
First Copy Output Time
1-28
Warm-up Time is defined as the time when the printer changes from Power-
On to Standby mode.
Standard Configuration: 30 seconds or less
Environmental Temperature: 22° C (72° F)
Humidity: 55% RH
First Print Output Time (FPOT) is defined as the time from when the engine
receives a Start signal in Ready state, until a single page is printed and
delivered to the output tray.
The following conditions are applied:
The Controller does not keep the print engine waiting.
The printer is at Ready mode (Laser Unit Motor Off, Fuser Ready).
Paper is A size Short-Edge Feed (SEF).
Process control time is not included.
Mode
FPOT (sec.)
Color
As fast as 10.0
Mono
As fast as 10.0
First Copy Output Time (FCOT) is defined as the time slot when the Start
button is pressed until the trail edge of the first copied media passes the
printer Exit Roller.
The following conditions are applied:
The Controller does not keep the print engine waiting.
The printer is at Ready mode (Laser Unit Motor Off, Fuser Ready).
Paper is A size Short-Edge Feed (SEF).
Document is on the document glass (Document setting: Platen mode).
Media: Media feed from the standard media tray.
Mode
FCOT (sec.)
Color
As fast as 11.1
Mono
As fast as 20.0
Phaser 6180MFP Multifunction Printer Service Manual