Transfer Unit Crum Error - Xerox Phaser 6180MFP Service Manual

Transfer Unit CRUM Error

Phaser 6180MFP Multifunction Printer Service Manual
The Transfer Unit CRUM ID error is detected. The following troubleshooting
procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Ensure the Transfer Unit is installed correctly.
Cycle printer power.
If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Transfer Unit, PL4.1.1
MCU Board, PL9.2.13
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the Transfer Unit for correct
1
installation.
2. Is the Transfer Unit correctly installed?
Does the error still occur when the printer is
2
turned On?
3 1. Replace the Transfer Unit (page 8-9).
2. Does the error still occur when the printer
is turned On?
094-330: Transfer CRUM Error (IOT CRUM ID Error)
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-10
"Map 4 - LVPS and MCU Board" on
page 10-13
"Xerographic" on page 10-34
Error Messages and Codes
Yes No
Go to step 3. Reseat the
Transfer Unit
(page 8-9).
Go to step 2.
Go to step 3. Complete.
Replace the Complete.
MCU Board
(page 8-88).
3-67