Jam At Duplexer - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

Jam at Duplexer

3-42
The Duplex Jam Sensor indicates the paper did not reach the sensor on time
or that paper remains in the Chute Assembly Out. The following
troubleshooting procedure applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Check for obstruction or debris in the Exit Chute Out or paper path.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Front Cover Harness, PL1.2.13
Feeder Unit, PL3.2.1
PH Turn Clutch, PL3.2.25
Registration Sensor Harness,
PL3.2.37
Exit Out Chute, PL6.1.1
Fuser Harness, PL6.1.11
Duplex Gate Chute, PL6.1.13
Main Drive, PL8.1.2
Drive Assembly, PL8.1.7
MCU Board, PL9.2.13
Right Side Harness, PL10.1.12
Duplex Unit, PL12.1.1
Duplex Unit Board, PL12.1.5
Duplex Harness, PL12.1.18
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the Front Cover Latch. Open
and close the Front Cover.
2. Does the error still occur when
printing?
1. Reseat the Fuser (page 8-12).
2
2. Does the error still occur when
printing?
077-907: Jam at Duplexer (IOT Remain Duplex Jam)
Wiring and Plug/Jack Map Reference
"Map 1 - Electrical and Drive" on
page 10-10
"Map 2 - Laser Unit and Feeder" on
page 10-11
"Map 4 - LVPS and MCU Board" on
page 10-13
"Map 5 - Duplex Unit" on page 10-14
"Tray 1 (MPT) and Registration" on
page 10-26
"Main Drive" on page 10-28
"Feeder" on page 10-30
"Fuser" on page 10-40
"Duplex Wiring Diagram" on page 10-48
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Complete.
Go to step 3. Complete.