Xerox Phaser 6180MFP Service Manual page 467

Phaser 6180MFP Multifunction Printer Service Manual
Sub Motor (FULL2/FULL1/HALF/LOW)
Caution
The Sub Motor is located in the Main Drive. When performing this
procedure, remove and cover the Print Cartridges to avoid exposure to
light.
Note
The rotational speed of the Sub Motor is as follows:
LOW < HALF < FULL2 < FULL1
1. Enter the Service Diagnostic menu (page 4-5).
2. Open the Front Cover.
3. Remove the Transfer Unit (page 8-9).
4. Remove the Print Cartridges (page 8-11).
5. Use a paper clip to secure the Interlock Switch.
6. Perform the Sub Motor (FULL2/FULL1/HALF/LOW) test:
Engine Diag
7. Verify that the Sub Motor is running and the three gears are rotating.
8. Press the Stop button to stop the Sub Motor test.
9. Remove the paper clip from the Interlock Switch.
> Motor Test > Sub Motor
General Troubleshooting
Printer Diag
(FULL2/FULL1/HALF/LOW).
s6180mfp-174
>
4-55