Mpc Communication Error - Xerox Phaser 6180MFP Service Manual

Error Messages and Codes

MPC Communication Error

3-106
Communication error has occurred between the MPC and the Controller
during download. The following troubleshooting procedure applies to this
error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.20
Multi-Protocol Network Card
(Option), PL9.1.23
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the Multi-Protocol Network
Card (MPC) for correct installation.
2. Is the MPC installed on the Image
Processor Board?
1. Check the printer firmware.
2
2. Does the firmware have the correct
version?
3 1. Check the MPC for correct
installation. Reseat the MPC
(page 8-95).
2. Does the error still occur after the
firmware has been updated?
1. Check the Image Processor Board
4
for correct installation. Reseat the
Image Processor Board
(page 8-90).
2. Does the error still occur after the
firmware has been updated?
016-740: MPC Comm. Error (Download Comm Error)
Wiring and Plug/Jack Map References
Phaser 6180MFP Multifunction Printer Service Manual
Yes No
Go to step 2. Install the MPC
(page 8-95).
Go to step 2.
Go to step 3. Update the
firmware
("Firmware
Update" on
page A-3).
Go to step 4. Complete.
Go to step 5. Complete.