Out Of Memory/Hard Drive Full - Xerox Phaser 6180MFP Service Manual

Out of Memory/Hard Drive Full

Phaser 6180MFP Multifunction Printer Service Manual
The printer memory is full and cannot continue to print. Print job requires
additional memory. The following troubleshooting procedure applies to these
errors.
Applicable Chain Link
Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Image Processor Board, PL9.1.20
Memory Card (Option), PL9.1.22
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the required memory for the
1
print job.
2. Print a small size file (example as a
Windows test print).
3. Does the error still occur?
1. Reseat the memory card
2
(page 8-94).
2. Does the error still occur?
3 1. Check the memory card capacity.
Print the printer Configuration Page:
System
Configuration.
2. Does the memory meet the print job
requirements?
4 1. Replace the memory card
(page 8-94).
2. Does the error still occur?
016-718: Out of memory
016-982: Hard Drive Full (Disk Full)
Wiring and Plug/Jack Map References
> Information Pages >
Error Messages and Codes
Yes No
Go to step 2. Add memory
card or separate
the print job.
Go to step 3. Complete.
Go to step 4. Replace the
Image
Processor
Board
(page 8-90).
Replace the Complete.
Image
Processor Board
(page 8-90).
3-99