Mcu Firmware Error - Xerox Phaser 6180MFP Service Manual

MCU Firmware Error

Phaser 6180MFP Multifunction Printer Service Manual
Firmware error has been detected. The following troubleshooting procedure
applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
MCU Board, PL9.2.13
Note
If the error occurred after replacing the MCU Board, transfer the internal
data from the old MCU Board to the new MCU Board.
Troubleshooting Procedure Table
Step Actions and Questions
1. Turn the printer power Off and back
1
On.
2. Does the error still occur?
2 1. Check the firmware version:
>
Configuration.
2. Does the firmware have the
3 1. Reseat the MCU Board (page 8-88).
2. Does the error still occur?
1. Replace the MCU Board
4
(page 8-88).
2. Does the error still occur when the
printer is turned On?
024-340: MCU Firmware Error (IOT Firmware Error)
System
Information Pages >
correct version?
Error Messages and Codes
Wiring and Plug/Jack Map References
"General Wiring Diagram" on page 10-23
Yes
Go to step 2.
Go to step 3.
Go to step 4.
Refer to
"Electrical
Noise" on
page 4-108,
Troubleshooting
chapter.
No
Complete.
Update the
firmware
("Firmware
Update" on
page A-3).
Complete.
Complete.
3-117