Scanner And Copier Errors; Scanner Adf Cover Open - Xerox Phaser 6180MFP Service Manual

Scanner and Copier Errors

Scanner ADF Cover Open

Phaser 6180MFP Multifunction Printer Service Manual
ADF Cover Open error has occurred. The following troubleshooting procedure
applies to this error.
Applicable Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
ADF Scanner Assembly, PL11.1.1
Troubleshooting Procedure Table
Step Actions and Questions
Is the ADF Cover closed?
1
1. Check the wiring harness connector
2
P/J60 on the Scanner Controller
Board. Reseat the connector.
2. Does the error still occur when the
printer is turned On?
3 1. Replace the ADF Scanner Assembly
(page 8-103).
2. Does the error still occur when the
printer is turned On?
005-301: Scanner ADF Cover Open (ADF Cover Open)
Wiring and Plug/Jack Map References
"Map 3 - Image Processor Board and
Dispenser Motors" on page 10-12
"Automatic Document Feeder Wiring
Diagram" on page 10-53
Error Messages and Codes
Yes No
Go to step 2. Close the ADF
Cover.
Go to step 3. Complete.
Replace the Complete.
Scanner
Controller Board
(page 8-99).
3-167