Right Cover (Pl1.1.9) - Xerox Phaser 6180MFP Service Manual

Right Cover (PL1.1.9)

Phaser 6180MFP Multifunction Printer Service Manual
1. Open the Front Cover.
2. Remove the Fuser (page 8-12).
3. Remove the Rear Cover (page 8-18).
4. Remove the Bottom Cover (page 8-19).
5. Remove the Right Pole Inner Cover (page 8-21).
6. Remove the Right Pole Cover (page 8-22).
7. Remove 2 screws (10 mm) and 2 screws (6 mm) securing the Right
Cover.
8. Use a flat tip screwdriver to release the plastic tabs from the notches on
the top and rear sides of the printer frame.
9. Slide the rear of the Right Cover slightly outward to release the 1 hook on
the Right Cover and slide the Right Cover outward.
10. Release the 2 hooks on the front section of the Right Cover and slide the
Cover backward to remove it.
Tab
10 mm
Tabs
Replacement Note
Align the Right Side
Cover on the inside
of the Front Cover.
Replacement Note Replacement Note
Insert the top and bottom tabs of the Right Side Cover at an angle in
order to fit the Right Side Cover in the correct position.
Be sure the notch on the printer frame is secured to the top tab of the
Left Cover.
Service Parts Disassembly
Lock Lever
Top View
6 mm
6 mm
10 mm
s6180mfp-212
8-23