Xerox Phaser 6180MFP Service Manual page 231

Phaser 6180MFP Multifunction Printer Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
1. Check the Duplex Gate Chute for
3
correct installation. Reseat the
Duplex Gate Chute (page 8-68).
2. Does the error still occur when
printing?
4 1. Check the Exit Out Chute for correct
installation.
2. Is the Exit Out Chute correctly
installed?
5 1. Perform the Duplex Jam Sensor test
(page 4-41): Service Mode
Printer Diag >
Sensor Test >
2. Does the number increase by 1
when the Actuator of the Sensor is
activated?
6 1. Perform the Duplex Clutch test
(page 4-71): Service Mode
Printer Diag >
Test > Duplex Clutch.
2. Does the Clutch operate properly?
7 1. Perform the Duplex Motor test
(page 4-58): Service Mode
Printer Diag >
Test > Duplex Motor.
2. Does the Motor operate properly?
1. Perform the Tray 1 (MPT) Turn
8
Clutch test (page 4-66):
Mode > Printer Diag
> Motor Test >
Clutch.
2. Does the Clutch operate properly?
1. Perform the Tray 2 Motor test
9
(page 4-56): Service Mode
Printer Diag >
Test > Tray 2 Motor.
2. Does the Motor operate properly?
1. Check the wiring harness
10
connectors P/J23 and P/J234
between the Tray 2 Turn Clutch and
the MCU Board.
2. Are the connectors securely
connected?
Yes
Go to step 4.
Go to step 5.
Go to step 6.
>
Engine Diag >
DuplexJamSensor.
Go to step 7.
>
Engine Diag > Motor
Go to step 8.
>
Engine Diag > Motor
Go to step 9.
Service
> Engine Diag
Tray 1 (MPT) Turn
Replace the
MCU Board
>
Engine Diag > Motor (page 8-88).
Go to step 10.
Error Messages and Codes
No
If the Duplex
Gate Chute is
damaged,
replace the
Duplex Gate
Chute
(page 8-68).
Reseat the Exit
Out Chute. If
damaged,
replace the Exit
Out Chute
(page 8-67).
Go to step 16.
Go to step 16.
Go to step 16.
Go to step 10.
Go to step 13.
Reconnect the
connectors.
3-43