Xerox Phaser 6180MFP Service Manual page 225

Phaser 6180MFP Multifunction Printer Service Manual
Troubleshooting References Table
Applicable Parts
Registration Clutch, PL3.1.19
Feeder Unit, PL3.2.1
Regi Metal Roll, PL3.2.6
Regi Rubber Roll, PL3.2.7
Registration Sensor, PL3.2.30
Registration Sensor Harness,
PL3.2.37
Transfer Unit, PL4.1.1
Fuser Harness, PL6.1.11
Main Drive, PL8.1.2
Drive Assembly, PL8.1.7
MCU Board, PL9.2.13
Right Side Harness, PL10.1.12
Troubleshooting Procedure Table
Step Actions and Questions
1. Check the paper condition.
1
2. Is the paper damaged?
1. Open and close the Front Cover to
2
check the latches.
2. Does the error still occur when
printing?
3 1. Reseat the Fuser (page 8-12).
2. Does the error still occur when
printing?
4 1. Perform the Exit Sensor test
(page 4-42): Service Mode
Printer Diag >
Sensor Test >
2. Does the number on the Control
Panel increase by 1 when the
Actuator of the Exit Sensor is
activated?
1. Perform the Registration Sensor
5
test (page 4-43):
Printer Diag >
Sensor Test >
2. Does the number on the Control
Panel increase by 1 when the
Actuator of the Registration Sensor
is activated?
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-10
"Map 2 - Laser Unit and Feeder" on
page 10-11
"Map 4 - LVPS and MCU Board" on
page 10-13
"Main Drive" on page 10-28
"Feeder" on page 10-30
"Fuser" on page 10-40
Yes
Replace the
paper.
Go to step 2.
Go to step 3.
Go to step 4.
Go to step 5.
>
Engine Diag >
Exit Sensor.
Go to step 6.
Service Mode >
Engine Diag >
Regi Sensor.
Error Messages and Codes
No
Go to step 2.
Complete.
Complete.
Go to step 13.
Go to step 17.
3-37