Adc Sensor Error (Error Code 02) - Xerox Phaser 6180MFP Service Manual

ADC Sensor Error (Error Code 02)

Phaser 6180MFP Multifunction Printer Service Manual
The ADC Sensor has detected density error. The following troubleshooting
procedure applies to this error.
Applicable Chain Link
Chain Link
Code 02)
Initial Actions
Ensure the Transfer Unit and surrounding area is free of waste toner.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Front Cover Harness, PL1.2.13
Transfer Unit, PL4.1.1
Laser Unit, PL5.1.12
Print Cartridge (C/M/Y/K),
PL5.1.17-20
MCU Board, PL9.2.13
Right Side Harness, PL10.1.12
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Check the Transfer Unit for correct
installation.
2. Is the Transfer Unit correctly
installed?
Does the error still occur when the
2
printer is turned On?
3 1. Check the Print Cartridges for
correct installation.
2. Are the Print Cartridges correctly
installed?
Does the error still occur when the
4
printer is turned On?
092-651: ADC Sensor Error (IOT ADC Sensor Error) (Error
Wiring and Plug/Jack Map References
"Map 1 - Electrical and Drive" on
page 10-10
"Map 4 - LVPS and MCU Board" on
page 10-13
"Xerographic" on page 10-34
Error Messages and Codes
Yes No
Go to step 3. Reseat the
Transfer Unit
(page 8-9).
Go to step 2.
Go to step 3. Complete.
Go to step 5. Reseat the Print
Cartridges
(page 8-11).
Go to step 4.
Go to step 5. Complete.
3-141