Xerox Phaser 6180MFP Service Manual page 226

Error Messages and Codes
3-38
Troubleshooting Procedure Table (continued)
Step Actions and Questions
1. Perform the Main Motor test
6
(page 4-54): Service Mode
Printer Diag >
Test > Main Motor.
2. Does the Motor operate properly?
7 1. Perform the Sub Motor test
(page 4-55): Service Mode
Printer Diag >
Test > Sub Motor.
2. Does the Motor operate properly?
8 1. Perform the Tray 2 Motor test
(page 4-56): Service Mode
Printer Diag >
Test > Tray 2 Motor.
2. Does the Motor operate properly?
1. Perform the Regi Clutch test
9
(page 4-65): Service Mode
Printer Diag >
Test > Regi Clutch.
2. Does the Clutch operate properly?
1. Check the Fuser.
10
2. Are there any remaining paper or
debris in the Fuser?
1. Check the Regi Rubber Roll and
11
Regi Metal Roll for damages and
correct installation.
2. Are the rollers correctly installed?
3. Are there any damages on the
rollers?
12 1. Check the Transfer Unit for correct
installation. Reseat the Transfer Unit
(page 8-9).
2. Does the error still occur when
printing?
13 1. Check the wiring harness
connectors P/J17 and P/J171
between the MCU Board and the
Fuser.
2. Are the connectors securely
connected?
Check the Fuser Harness for
14
continuity.
1. Disconnect P/J17 from the MCU
Board.
2. Disconnect P/J171 from the Fuser.
3. Check continuity between P/J17 <=>
P/J171.
Yes
Go to step 7.
>
Engine Diag > Motor
Go to step 8.
>
Engine Diag > Motor
Go to step 9.
>
Engine Diag > Motor
Go to step 10.
>
Engine Diag > Motor
Remove the
debris.
Go to step 12.
Replace the
MCU Board
(page 8-88).
Go to step 14.
Go to step 15.
Phaser 6180MFP Multifunction Printer Service Manual
No
Go to step 22.
Go to step 25.
Go to step 28.
Go to step 31.
Go to step 11.
Replace the
Feeder Unit
(page 8-47).
Complete.
Reconnect the
connectors.
Replace the
Fuser Harness.