Eeprom Error - Xerox Phaser 6180MFP Service Manual

EEPROM Error

Phaser 6180MFP Multifunction Printer Service Manual
EEPROM error has occurred. The following troubleshooting procedure
applies to these errors.
Applicable Chain Link
Chain Link
Chain Link
Chain Link
Initial Actions
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Scanner Controller Board, PL9.1.1
Troubleshooting Procedure Table
Step Actions and Questions
1 1. Turn the printer power Off and back
On.
2. Does the error still occur?
2 1. Check the Country setting:
Admin Menu
Country.
2. Is the Country setting correct?
1. Check the Scanner Controller Board
3
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2. Does the error still occur when the
printer is turned On?
117-315: EEPROM Error
117-350: EEPROM Error
117-362: EEPROM Error
Wiring and Plug/Jack Map References
System
> Fax Settings >
Error Messages and Codes
Yes No
Go to step 2. Complete.
> Go to step 3. Set the correct
country setting.
Replace the Complete.
Scanner
Controller Board
(page 8-99).
3-223