Toyota T100 1996 Service Manual page 396

DI−132
Flashing
ON
OFF
0.13 Seconds
1996 TOYOTA T100 (RM449U)
DIAGNOSTICS − ENGINE (5VZ−FE)
NOTICE:
When simulating symptoms with an OBD II scan tool (ex-
cluding TOYOTA hand−held tester) to check the DTCs, use
normal mode. For code on the DTC chart subject to "2 trip
detection logic", turn the ignition switch OFF after the
symptom is simulated the 1st time. Then repeat the simula-
tion process again. When the problem has been simulated
twice, the MIL lights up and the DTCs are recorded in the
ECM.
3. INSPECT DIAGNOSIS (Check Mode)
HINT:
TOYOTA hand−held tester only:
Compared to the normal mode, the check mode has an in-
creased sensitivity to detect malfunctions.
Furthermore, the same diagnostic items which are detected in
the normal mode can also be detected in the check mode.
(a) Check the DTC.
(1) Initial conditions
S
S
S
S
(2) Turn the ignition switch OFF.
(3) Prepare the TOYOTA hand−held tester.
(4) Connect the TOYOTA hand−held tester to DLC3 at
the lower of the instrument panel.
(5) Turn the ignition switch ON and push the TOYOTA
hand−held tester switch ON.
(6) Switch the TOYOTA hand−held tester normal mode
to check mode (Check that the MIL flashes.).
(7) Start the engine. (The MIL goes out after the engine
start.)
(8) Simulate the conditions of the malfunction de-
scribed by the customer.
NOTICE:
Leave the ignition switch ON until you have checked the
DTCs, etc.
(9) After simulating the malfunction conditions, use the
FI3605
TOYOTA hand−held tester diagnosis selector to
check the DTCs and freezed frame data, etc.
HINT:
Take care not to turn the ignition switch OFF. Turning the ignition
switch OFF switches the diagnosis system from check mode to
normal mode. so all DTCs, etc. are erased.
(10) After checking the DTC, inspect the applicable cir-
cuit.
Battery positive voltage 11 V or more
Throttle valve fully closed
Transmission in "P" or "N" position
Air conditioning switched OFF