Dell PowerConnect 6224 Command Line Interface Manual page 276

the source MAC address and destination MAC address validations are
disabled as a result of the second command. Use the "no" form of this
command to disable additional validation checks.
Syntax
ip arp inspection validate {[src-mac] [dst-mac] [ip]}
no ip arp inspection validate {[src-mac] [dst-mac] [ip]}
src-mac
•
—
dst-mac
•
—
• ip For validating the IP address of an ARP packet.
—
Default Configuration
There is no additional validation enabled by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command
Example
console(config)#ip arp inspection validate src-mac
dst-mac ip
console(config)#ip arp inspection validate src-mac ip
console(config)#ip arp inspection validate dst-mac ip
console(config)#ip arp inspection validate ip
ip arp inspection vlan
Use the ip arp inspection vlan command to enable Dynamic ARP Inspection
on a single VLAN or a range of VLANs. Use the "no" form of this command
to disable Dynamic ARP Inspection on a single VLAN or a range of VLANs.
276
Dynamic ARP Inspection Commands
For validating the source MAC address of an ARP packet.
For validating the destination MAC address of an ARP packet.