Dell PowerConnect 6224 Command Line Interface Manual page 262

Syntax
ip dhcp snooping limit { none | rate
no ip dhcp snooping limit
pps —The maximum number of packets per second allowed (Range:
•
0–300 pps).
seconds — The time allowed for a burst (Range: 1–15 seconds).
•
Default Configuration
The default maximum rate is 15 packets per second (pps).
The default burst interval is 1 second.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Examples
console(config-if-1/g1)#ip dhcp snooping limit none
console(config-if-1/g1)#ip dhcp snooping limit rate
100 burst interval 1
ip dhcp snooping log-invalid
Use the ip dhcp snooping log-invalid command to enable logging of DHCP
messages filtered by the DHCP Snooping application. Use the "no" form of
this command to disable logging.
Syntax
ip dhcp snooping log-invalid
no ip dhcp snooping log-invalid
262
DHCP Snooping Commands
pps
[ burst interval
seconds
] }