Interfaces (Cli Procedure) - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
Related
Documentation
Configuring Autorecovery From the Disabled State on Secure or Storm Control

Interfaces (CLI Procedure)

Related
Documentation
3156
®
OS for EX Series Ethernet Switches, Release 10.4
Example: Configuring Proxy ARP on an EX Series Switch on page 3125
Verifying That Proxy ARP Is Working Correctly on page 1631
Configuring Routed VLAN Interfaces (CLI Procedure) on page 1601
An Ethernet switching access interface on an EX Series switch might shut down or be
disabled as a result of one of the following port-security or storm-control configurations:
MAC limiting— mac-limit
MAC move limiting—
mac-move-limit
Storm control—
storm-control
You can configure the switch to automatically restore the disabled interfaces to service
after a specified period of time. Autorecovery applies to all the interfaces that have been
disabled due to MAC limiting, MAC move limiting, or storm control errors.
NOTE: You must specify the disable timeout value for the interfaces to recover
automatically. There is no default disable timeout. If you do not specify a
timeout value, you need to use the
command to clear the errors and restore the interfaces or the specified
interface to service.
To configure autorecovery from the disabled state due to MAC limiting, MAC move limiting,
or storm control shutdown actions:
[edit ethernet-switching-options]
user@switch# set port-error-disable disable-timeout 60
Example: Configuring Port Security, with DHCP Snooping, DAI, MAC Limiting, and MAC
Move Limiting, on an EX Series Switch on page 3073
Configuring MAC Limiting (CLI Procedure) on page 3139
Example: Configuring Storm Control to Prevent Network Outages on EX Series Switches
on page 3015
Understanding MAC Limiting and MAC Move Limiting for Port Security on EX Series
Switches on page 3062
Understanding Storm Control on EX Series Switches on page 3013
statement is configured with action
statement is configured with action
statement is configured with the action
clear ethernet-switching port-error
shutdown .
shutdown
shutdown
Copyright © 2010, Juniper Networks, Inc.
.
.