Table of Contents
Advertisement
M-series and MX-series Devices
Configuring Graceful Restart for RIPng (NSM Procedure)
338
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 186: RIPng Configuration Details
Task
Configure RIPng.
You can configure graceful restart parameters specifically for RIPng using the Graceful
Restart option.
To configure graceful restart for RIPng in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Ripng.
4.
Add or modify settings as specified in Table 187 on page 339.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1.
In the Comment box, enter the comment.
2.
From the Metric In list, select the metric value.
Range: 1 through 15
Default: 1
3.
From the Holddown list, select the estimated time to wait
before making updates to the routing table.
Range: 10 through 180 seconds
Default: 180 seconds
4.
From the Route Timeout list, select the estimated time to
wait before making updates to the routing table.
Range: 30 through 360 seconds
Default: 180 seconds
5.
From the Update Interval list, select the estimated time to
wait before making updates to the routing table.
Range: 10 through 60 seconds
Default: 30 seconds
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?