Install Sim Cards; Apply Dielectric Grease Over Sim Contacts - Digi IX10-00G4 User Manual

Hardware setup

Install SIM cards

To install SIM cards:
1. Use a screw driver to remove the SIM slot cover.
2. For high-vibration environments, apply a thin layer of dielectric grease to the SIM contacts.
Note If the IX10 device is used in an environment with high vibration levels, SIM card contact
fretting may cause unexpected SIM card failures. To protect the SIM cards, Digi strongly
recommends that you apply a thin layer of dielectric grease to the SIM contacts prior to
installing the SIM cards. See
over SIM Contacts
3. Insert the SIM card(s) into the SIM sockets. Insert the end of each SIM card with the chamfered
corner positioned as indicated. Push the SIM in until it clicks into place.
4. After SIM cards are installed, replace the SIM slot cover.
Apply Dielectric Grease over SIM Contacts
Note Digi recommends using either ...the Loctite® LB 8423 Dielectric Grease or Synco Lube® Silicone
Dielectric Grease.
IX10 User Guide
Apply Dielectric Grease over SIM ContactsApply Dielectric Grease
for instructions.
Install SIM cards
34