Table of Contents
Advertisement
12 [Alarm] to set the alarm
12.2 [Alarm] for setting the output terminal
Set the port number to which the command alarm is received.
Settable range:1～65535
The following port numbers cannot be set because they are used by this computer.
20、 21、 23、 25、 42、 53、 67、 68、 69、 80、 110、 123、 161、 162、 443、 554、 995、 1883、
8883、 10669、 10670、 59000～61000
[Alarm deactivation time]
Sets the time when the alarm is detected and the detection operation is not executed. For
example, this setting prevents sending too much mail to a mobile terminal or a tablet terminal
when it is set to send mail notification by an alarm.
0.5s、 1 ～ 600s
[Alarm test]
Clicking [Execute] performs the alarm test function.
12.2
[Alarm] for setting the output terminal
Click [Alarm] on the Alarm page. Refer to the following how to display and operate the Advanced
menu.
→5.1 How to display
→5.2 How to operate
[Note:]
・Alarm detection time is managed for each alarm type. For example, the operation
detection alarm and disturbance detection alarm are detected even during the no
alarm detection time of the command alarm.
・[MULTI] The port numbers 32768 to 49151 cannot be set.
[Note:]
・When the alarm test function is executed, the computer detects the command
alarm.
This function can be used to record an SD Memory Card triggered by alarm
detection or to confirm notification to an external device. Use the external device
specified as the notification destination and the system log of this equipment to
check the related settings.
・The alarm test function cannot be generated more than once within the alarm
detection time.
337
Advertisement
Table of Contents
